📄️ Introduction
Product Features
📄️ Firmware Update
* The firmware has been pre-flashed at the factory.
📄️ Connect to WiFi
* The on-board antenna of this product can only be used for reception. The transmitting antenna needs to be installed by yourself, and the antenna terminal is ipex3.
📄️ Connect to Klipper
* AirClick must be connected to the same network as the target printer.
📄️ Connect to RRF
* AirClick must be connected to the same network as the target printer.
📄️ Connect to BambuLab
* AirClick must be connected to the same network as the target printer.
📄️ 按钮添加
* 无线按钮需要将电池安装上，电池型号是CR927
📄️ Wired Connection Klipper Configuration
* The STM32F072 needs to be flashed with firmware and connected to klipper; otherwise, the wired connection operation is not supported.
📄️ 3D Model and Schematic Diagram
AirClick 3D Model