Skip to main content

Connect to Klipper

Important Note
  • AirClick must be connected to the same network as the target printer.
  1. Click on the System Settings on the left.
  1. Select Klipper for Printer Type.
  2. Enter the IP address of the klipper machine in Moonraker IP.
  3. Enter the port of the klipper host in Moonraker Port. The default is 7125. If the host uses other ports, you need to enter the corresponding port yourself.
  4. Ignore Apikey. It is not supported for the time being.
  1. After configuring as shown in the above figure, click Submit in the lower right corner to save the configuration.
  2. After a correct connection, a prompt will appear at the top of the web page.
  1. If the connection fails:
    • Check if the IP address and port are correct.
    • Check if the printer and AirClick are connected to the same network.
    • Check if the klipper host is running normally.
    • Check if the browser can open the web page of the klipper host.