Skip to main content

Connect to BambuLab

Important Tips
  • AirClick must be connected to the same network as the target printer.
  • Only LAN local area network mode is supported to connect to BambuLab printers.

  1. Turn on the LAN mode (LAN Only Mode) of the BambuLab printer.

    • Turn on the BambuLab printer screen.
    • Settings -> LAN Mode (LAN Only Mode) -> Enable

  2. Click on the system settings on the left.

  3. Select BambuLab for Printer Type.

  4. Click the button to refresh the device list.

  5. Select the printer.

    • If your printer never refreshes and appears, you can choose to enter it custom. Manually enter the IP address and serial number of the printer.

  6. Fill in the access code.

    • The access code is the LAN mode access code of the printer, which can be viewed in the printer's settings as per step 1.

  7. After configuring as shown in the above figure, click Submit in the lower right corner to save the configuration.

  8. After a correct connection, a prompt will appear at the top of the web page.

  9. If the connection fails:

    • Check if the IP address is correct.
    • Check if the printer and AirClick are connected to the same network.
    • Check if the printer has enabled the LAN mode.
    • Check if the access code is filled in incorrectly.